The Torlife™ WB system provides an extremely hard-wearing decorative finish combined with a Class 0 fire rating when applied to new, bare or stripped surfaces. In the event of a fire, the coating system inhibits the surface spread of flame across the painted surfaces.
Graffiti can be removed from the painted surfaces by using the Tor range of Graffiti removers. This allows the fire rating of the coated surfaces to be maintained throughout the life of the system.
Aqualife™ WSE Primer (EP131), a two pack adhesion promoting primer for new, bare or stripped surfaces.
2nd Coat & 3rd Coat
Torlife™ WB Gloss Finish (PU862), or Torlife™ WB Satin Finish (PU865), a two pack water-based anti – graffiti finish.
Normally applied to new, bare or stripped internal surfaces including the following: Plaster, plasterboard, masonry, brick, concrete and ceramic tiles.
Torlife™ WB is suitable for any internal surfaces where effective protection against graffiti is needed, but typical areas include walls and ceilings in the following locations:
Graffiti can be safely and easily removed from all of Tor Coatings anti-graffiti range, by using the Torclean™ Pre-wipe (SS454001) and Torclean™ Graffiti Remover Wipe (SS455001) or by using the Torclean™ Graffiti Prewash (DM416) and the Torclean™ “G” Graffiti Remover (DM424).
Only Tor Coatings remover wipes and sprays should be used, as other materials may damage the painted surface, resulting in system failure and permanent graffiti damage.
The use of abrasive pads and household detergents should never be considered, unless otherwise instructed by a representative of Tor Coatings Ltd.
The following specification is included for demonstrative purposes only and would be suitable for use over well adhered existing coatings. Always consult a representative of Tor Coatings prior to specifying or applying.
Aqualife™ WSE Primer
By brush or medium pile roller apply one full coat of Aqualife™ WSE Primer (EP131) at a coverage rate of 10m² per litre. Minimum overcoating time is 16 hours. Maximum overcoating time is 7 days.
Torlife™ WB Satin Finish
By brush or medium pile roller apply two full coat of Torlife™ WB Satin Finish (PU865) at a coverage rate of 10m² per litre per coat. Allow to dry between coats. Minimum overcoat time is 4 hours. Maximum overcoat time is 7 days.
Tor Coatings offers a free site survey service and all of our Area Business Managers are fully trained and able to carry out full site assessments. A detailed and bespoke specification will then be issued.
Please contact Tor Coatings on 0191 410 6611 to arrange your free site survey.
Tor Coatings’ national team of Area Business Managers is supported by a dedicated customer services team, a team of experienced paint chemists and a dedicated technical help desk. Call 0191 411 3148 for assistance from our helpdesk or visit www.tor-coatings.com to find out more.