During this unprecedented situation regarding the Covid-19 virus we kindly ask that all general enquiries are sent via email to email@example.com and technical questions to firstname.lastname@example.org instead of by telephone. We are operating with reduced staff and will do our utmost to respond in a timely manner. We hope to resume normal practices as soon as possible and look forward to speaking to you all soon. Thank you for your support and patience at this time.Close Popup
Aquatread™ EP Floor Systems are a range of two-pack water based epoxy floor coatings which combine durability, resistance to chemicals, oil and grease, with very low odour when applied. Recommended for bare concrete and previously painted internal floor surfaces, with an Anti-Static top-coat available for use in areas where electrostatic charges must be prevented or led off for safety reasons.
• Semi gloss finish
• Two-pack, easy and economical to use and apply
• Low odour, water based formula
• Extend lifetime of existing floor
• Very good resistance to oil and grease
• Hard wearing, good resistance to pedestrian and moderate mechanical traffic
• Seamless finish
• Can be made slip resistant by adding grits
• Easy maintenance and cleaning
• Available in a range of colours and finishes
1st Coat Aquatread™ EP Bonding Primer (EP157) – for previously painted
1st Coat Aquatread™ EP Binder/Sealer (EP158) – for bare surfaces
2nd & 3rd Coat Aquatread™ EP Floor Finish (EP234)
2nd & 3rd Coat Aquatread™ EP Anti-Static Floor Coating
Suitable for use on bare concrete and previously painted internal floor surfaces.
Aquatread™ EP Floor Systems is suitable for use in locations where solvent-based systems are not suitable:
The following specification For concrete floors (unpainted) is included for demonstrative purposes only.
Always consult a representative of Tor Coatings prior to specifying or applying.
By brush/roller/airless spray, apply one full coat of Aquatread™ Binder/Sealer (EP158) at a coverage rate of 6 square metres per litre. Allow to dry. Overcoating time minimum 16 hours, maximum 7 days.
By brush/lambswool roller, apply two full coats of Aquatread™ Floor Finish (EP233) at a coverage rate of 8 square metres per litre. Allow to dry. Overcoating time minimum 16 hours, maximum 72 hours.
Tor Coatings offer a free site survey service, and all of our Area Business Managers are fully trained and able to carry out full site assessments. A detailed and bespoke specification will then be issued.
Tor Coatings’ national team of Area Business Managers is supported by a dedicated customer services team, a team of experienced paint chemists and a dedicated technical help desk. Call 0191 411 3148 for assistance from our helpdesk or fill out the contact form to find out more.